Accurate Technology ProScale Manuel d'instructions télécharger pdf (Page 48)

Displays

The tables below show display options

that may be configured by the installer.

When shipped, displays are set to allow

the maximum number of options at

power-up. To limit the available

options, change the positions of the

internal jumpers. When changing

jumpers, first note their factory positions. Lifting the plastic connector off

its two posts and repositioning to another two posts changes the

jumper’s position. The center post for each jumper setting is always

common. The tables below show options for displays. BOLD type

indicates factory default settings.

A B

Jumper Positions

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 58 59

Pas de commentaire

Accurate Technology ProScale Manuel d'instructions Page 48