Accurate Technology ProScale Manuel d'instructions télécharger pdf (Page 36)

Standard and SPC Displays

Changing the Measurement Readout:

Press the MODE key (while in ABS mode) to change the measurement

readout. The current measurement readout is saved when power is off.

Readouts appear in the following order:

1. mm.

2. Decimal inches.

3. 16ths of an inch, each bar in the display's upper right corner

represents an additional 1/64

of an inch.

4. 32nds of an inch, each bar in the display's upper right corner

represents an additional 1/64

of an inch.

5. 64ths of an inch.

Setting ABS Position

When the display is in ABS mode (indicated by ABS in the upper left

corner of the display), a zero point is established by pressing the ZERO

key. All subsequent absolute measurements will reflect distance from

this point. The display should be locked to prevent accidental resetting.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 58 59

Pas de commentaire

Accurate Technology ProScale Manuel d'instructions Page 36