Accurate Technology ProScale Manuel d'instructions télécharger pdf (Page 33)

Basic and Incremental Displays

Changing the Measurement Readout:

Press the MODE key to change the measurement readout. The current

measurement readout is saved when power is off. Readouts appear in

the following order:

1. mm.

2. Decimal inches.

3. 16ths of an inch, each bar in the display's upper right corner

represents an additional 1/64

of an inch.

4. 32nds of an inch, each bar in the display's upper right corner

represents an additional 1/64

of an inch.

5. 64ths of an inch.

Setting Zero

A zero point is easily established by pressing the ZERO key when the

display is unlocked. All subsequent measurements will reflect distance

from this point.

The positions of the internal jumpers may be changed to limit the

available display options or change the resolution. See the display

options charts starting on page 48 for more information.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 58 59

Pas de commentaire

Accurate Technology ProScale Manuel d'instructions Page 33