Accurate Technology ProScale Manuel d'utilisateur télécharger pdf (Page 33)

ProScale M150, M250 and all products with General Purpose LCD Digital Displays 33 of 44

Pr8 – Automatic Power Off [0 to 60] Default = 15.

Sets the amount of time in ‘minutes without activity’ before the display

automatically turns off.

0 = Disables Auto Off.

Encoder motion or ON/OFF key “wake-ups” the display and resets the timer.

Pr9 – Auxiliary Keys Enable/Disable [0..7]

0 = ABS/INC, MON and HOLD Disabled

1 = ABS/INC Key Enabled

2 = MON Key Enabled

4 = HOLD Key Enabled

7 = All Keys Enabled

To enable keys, add up combination of key values. A value of 2 enables only the

MON key. A value of 7 enables all 3 Keys.

Pr10 – Offset Addition Enable [0, 1]

0 = Offset Addition Disabled

1 = Offset Addition Enabled.

SEE ALSO Pr11, Pr12, Pr13

Pr11 – Offset Addition 1 [-999.999 to 999.999in] or [-9999.99 to 9999.99mm]

When offset 1 is selected (see section 4 -Offset Addition), this value is added to

the current ABS position. Default = 1.000IN

Only active if Pr10 is set to 1. Note: Default is set in Inches

Pr12 – Offset Addition 2 [-999.999 to 999.999in] or [-9999.99 to 9999.99mm]

When offset 2 is selected (see section 4 -Offset Addition), this value is added to

the current ABS position. Default: 1.500IN

Only active if Pr10 is set to 1. Note: Default is set in Inches

Pr13 – Offset Addition 3 [-999.999 to 999.999in] or [-9999.99 to 9999.99mm]

When offset 3 is selected (see section 4 -Offset Addition), this value is added to

the current ABS position and displayed. Default: 2.000IN

Only active if Pr10 is set to 1. Note: Default is set in Inches

Pr14 – Output Signal Mode [0, 1]

Configures the hardware output signal for activation on MONitor drift conditions or

Upper/Lower limit alarm conditions. (24VDC displays only)

0 = Monitor drift,

1 = Limit.Alarm

Pas de commentaire

Accurate Technology ProScale Manuel d'utilisateur Page 33