Accurate Technology ProScale Manuel d'installation télécharger pdf (Page 11)

Manual Part # 800-1402-001 Rev E Page 11 of 48

SECTION 2 SET-UP

Mounting the Digital Readout

General Purpose & Basic DRO

The SURFACE MOUNT Digital Readout may be mounted:

• Using Velcro or Double sided tape

• Drilling out the 3 holes from the inside of the case

• Using any of the six holes on the back of the case which may tapped for M2

or 4-40 screws.

Panel Mount DRO

A cutout should be made in the panel at least 90mm x 90mm (3.6 x 3.6 inches),

but no larger than 93mm x 93mm (3.7 x 3.7 inches).

The cases of the Digital Readout are designed to "sandwich" panel thicknesses

between 3mm (0.125") and 20mm (0.750") between the front and rear Digital

Readout cover.

NOTE: If Panel is thinner than 3mm (0.125 in), shorter screws must be

used for the Digital Readout casing or damage to the front cover of the

Digital Readout will occur.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 47 48

Pas de commentaire

Accurate Technology ProScale Manuel d'installation Page 11