Accurate Technology Digi-Stop Spécifications télécharger pdf (Page 14)

Manual Part # 800-1070-001, Rev112012 Page 14 of 16

Readout Programming

Several functions of the Digi-Stop readout is user programmable. The following

describes what features and functions are available and how to change the

factory defaults to customize your Digi-Stop system..

To enter Programming Mode:

1. Press and hold the UNITS key then momentarily press the DATUM key.

2. The LCD will briefly display: PG on (Programming On), then

Pr 1, (indicating Programming Parameter #1)

3. Release the UNITS key

4. The value stored in Pr1 is displayed.

Once in the Programming Mode:

Moving up parameter list - Momentarily press the UNITS key to advance through

the Programming Parameter list, first displaying the Programming Parameter

number then the currently programmed value.

Moving down parameter list - Press and hold the ON/OFF key and momentarily

press the UNITS key to move backward through the Programming list.

Increase parameter value - Momentarily press the PLUS (+) key while displaying

a Programming Parameter Value to increase the setting.

Decrease parameter value - Momentarily press the MINUS (-) key while

displaying a Programming Parameter Value to decrease the setting.

Reset parameter value to default setting - Momentarily press the DATUM key

while displaying a Programming Parameter Value to reset the parameter to the

factory default value.

Exit programming mode - Press and hold the UNITS key. Momentarily depress

the DATUM key. The LCD will briefly display: PG oFF (Programming Off),

then return to normal operation. NOTE: The system will automatically exit

programming mode after 60 seconds of no key activity.

Momentarily press

Press & Hold

1 2 ... 9 10 11 12 13 14 15 16

Pas de commentaire

Accurate Technology Digi-Stop Spécifications Page 14